Free US shipping on orders $199 or more.
No filters applied
Shop a large selection of single gas monitors including H2S monitors from top brands like BW Honeywell, RAE Systems, and RKI Instruments. PK Safety offers single gas monitors for all needs, including: hydrogen sulfide (H2S), ammonia, oxygen (O2), sulfur dioxide (SO2), chlorine, carbon monoxide (CO), nitrogen dioxide, ethylene oxide, and more. We also offer 4-gas and multi-gas monitors.
A single-gas monitor is a portable device designed to detect the presence of a single target gas. They are used in a wide variety of areas where specific hazardous gases are likely present. The monitor comes with a sensor that will report dangerous levels, and some also display the percentage of gas in the atmosphere. It sends an electric signal to issue the reading when the sensor mixes with the target gas to produce a chemical reaction.
Most single gas monitors are made to be worn on the worker’s collar, helmet, or bag strap so they can continuously monitor the air they breathe as they movethrough the space. The device should be worn in the breathing zone, a ten-inch radius around the person’s nose and mouth, to keep readings as accurate as possible. Some models of ortable gas monitors come with rechargeable batteries that last the duration of the worker’s shift. Charge them at the end of each workday to prepare your equipment for the next user. Some monitors can run continuously for their entire life span — no need for calibration, sensor replacement, battery replacement or battery charging.
Each manufacturer has different rules about their specific instruments. We recommend calibrating at least every six months, or if your device fails a bump test. Recalibration resets the sensor to the default reading to improve the accuracy of the results. Use a cylinder of test gas to perform a bump test before the start of every shift to see if the sensor is accurate. The concentration of gas in the cylinder should match the reading listed on the monitor. Ensure the test gas has not expired, as the relative mix of gas may change over time. If the reading does not match what’s listed on the cylinder, you will need to recalibrate the gas monitor. Follow the directions in the owner’s manual to improve accuracy.
The LEL on a gas detector refers to the Lower Explosive Limit of the target gas. This is the lowest point of concentration at which the gas becomes flammable, increasing the chances of a flash fire. The LEL is expressed as a percentage per volume. Once the target gas reaches 100% LEL, the atmosphere is considered flammable. Be sure to check the LEL for the target gas and keep an eye on the LEL reading when occupying confined spaces.
Use this gas detection equipment to keep your team safe when occupying areas with hazardous gases. Contact PK Safety to learn more about the gas monitors listed on our website.
Confined Space Gas Monitor, H2S Monitor, So2 Monitor, Single Gas Co Monitor, BW Clip Single Gas Detector